Table of Contents
Advertisement
each numbers are as follows.
No.
Name
1
Memory
read
2
Memory
Write
3
Access
Bits
4
Write At
5
Memory
Offset
6
Memory
Write Data
7
Progress
Bar
8
Memory
Data
9
I/O Write
10
I/O Read
11
I/O Offset
12
I/O Read
Count
When press button, it read from 0 to 100000h (total
1MByte) at memory and mark a number (8) area.
When press button, it progressively write from 0 to
100000h at memory. So, first after execution "Memory
Write" and then execute "Memory Read", it confirms a
correct data.
(Notice)When memory read/write, an Auto bit of ADC
becomes certainly '0'.
It set up how does unit of the byte deal in case of
reading and writing at memory.
It record designated data to a specific address area by
32 bits word.
When data value record to a specific address of memory,
it is a value of offset
The data that will be written to a specific address of
memory.
When the data record to a specific address of memory, it
set up a value of Offset and Data that wanted value,
after that press "Write At" button. You want check
whether exactly writing or not, you can confirm to press
"Memory read" button.
It marks a progress situation, when the memory reading.
It marks a data which read it to memory.
When press button, it is writing specific I/O address.
When press button, it mark to a screen as reading
specific I/O address.
It set up Offset of the address that it want to read or write
in I/O area.
It set up I/O data amount to read.
* The reading or writing if I/O is always 32bit DWORD.
Description
25-
-
PCI-EK01 Users Manual (Rev 1.0)
Remark
Not apply Currently
Always
deal
32bits
16bit
Hexa-Decimal
16bit
Hexa-Decimal
16bit
Hexa-Decimal
Not apply Currently
http://www.daqsystem.com
with
Advertisement
Table of Contents
