Verifying Successful Installation/Led Behavior - Networkfleet 5500 Installation Manual

Verifying Successful Installation/LED Behavior

23
To verify successful installation, call Customer Care at 866.227.7323 and select Option 5.
LED Behavior for Sensors: When the Sensor Input Harness is detected by the unit, all LEDs
should be turned on solid for 10 seconds. When you engage Sensor 1 (if installed), the yellow
LED shall blink rapidly (1/4 second) every time a transition is detected (on to off/off to on).
When you engage Sensor 2 (if installed), the green LED shall blink rapidly (1/4 second) every
time a transition is detected (on to off/off to on). The sensor installation verification will take
one minute in total. Afterwards, all LEDs should be turned on for 10 seconds and then normal
LED behavior will resume.
To ensure activation is complete, the vehicle must be idled or driven for at least 15 minutes to
reach normal operating mode.
Note: If voltage does not meet the standards detailed in this guide, the installation may require
the use of a relay switch to properly connect the sensor.