Table of Contents
Advertisement
20
To Install
1. Units are shipped with a knock-out panel covering the sensor/serial ports. First, use an X-ACTO knife to slice off 2
of the 3 tabs in order to remove the knock-out panel.
2. Connect the Sensor Input Harness to the Sensor Port on the 5500 or 5200 device.
3. Verify installation by checking the LED behavior of the device (see page 23) and call Customer Care at 866.227.7323
and select Option 5.
4. Before secvvuring the device under the dashboard, make sure you have recorded the appropriate information on the
Sensor Installation Card included with the Sensor Input Harness. Once all information is recorded, follow the
instructions detailed on the card to update your fleet on www.networkfleet.com.
Serial Port
Sensor Port
Note: The optional window-mount GPS antenna may be used simultaneously with either of the Garmin cables or the
NMEA cable. The NMEA and Garmin cables may not be used simultaneously.
Optional Sensor Installation Instructions (cont.)
Data Port
Sensor Input
Harness
(Blue & Purple)
Advertisement
Table of Contents
