Table of Contents
Advertisement
22
Location data is available directly from the 5000 series hardware to another in cab device via our serial port
interface. The feed is in NMEA format and requires a 5000 series hardware device, a Networkfleet NMEA
Cable, and a terminating device such as a laptop that can accept NMEA data.
To Install
1. Units are shipped with a knock-out panel covering the sensor/serial ports. First, use an X-ACTO knife
to slice off 2 of the 3 tabs in order to remove the knock-out panel.
2. Connect the NMEA Cable to the Serial Port on the 5500 or 5200 device.
3. Verify installation by checking the LED behavior of the device and call Customer Care at 866.227.7323
and select Option 5. The device is operating normally when the rapid blinking ceases and the Green
LED begins to blink in a slow pattern (ON for 5 seconds and OFF for 1 second).
4. Before securing the device under the dashboard, make sure you have recorded the appropriate
information on the Installation Card included with the NMEA Cable. Once all information is recorded,
follow the instructions detailed on the card.
Note: The optional window-mount GPS antenna may be used simultaneously with either of the Garmin
cables or the NMEA cable. The NMEA and Garmin cables may not be used simultaneously.
Optional NMEA Feed Installation Instructions
Advertisement
Table of Contents
