Table of Contents
Advertisement
To Install
1. Units are shipped with a knock-out panel covering the sensor/serial ports. First, use an X-ACTO knife to slice off 2 of
the 3 tabs in order to remove the knock-out panel.
2. Connect the modified Garmin FMI Cable to the Serial Port on the 5500 or 5200 device.
3. Plug the other end of the modified Garmin FMI cable into the Garmin device.
4. Required: To verify installation and to enable Garmin functionality, call Customer Care at 866.227.7323 and select Option 5.
5. Before securing the device under the dashboard, make sure you have recorded the appropriate information on the
Garmin Installation Card included with the modified Garmin FMI Cable. Once all information is recorded, follow the
instructions detailed on the card to update your fleet on www.networkfleet.com.
Networkfleet is ONLY compatible with Garmin devices that support Fleet Management Interface Version 2.6 and higher.
The list of compatible units can be found here: www.garmin.com/solutions/pnd/supportedproducts.jsp (look for
"Supports Version 2.6 Fleet Management Interface" in the description).
All Garmin devices, even if they support Fleet Management Interface Version 2.6, will need a firmware update prior to
installation. Please contact your sales representative or Networkfleet Customer Care to obtain update instructions.
Note: The optional window-mount GPS antenna may be used simultaneously with either of the Garmin cables or the
NMEA cable. The NMEA and Garmin cables may not be used simultaneously.
Optional Garmin® Installation Instructions
21
Advertisement
Table of Contents
