Table of Contents
Advertisement
Universal Harness Installation
12
Blue Wire - Switched Power
• W ith the vehicle's engine OFF, use the voltmeter to locate an IGNITION line with switched power and
attach the Blue Wire to the line by splicing directly to the lead or by using a wire tap (recommended).
• Do NOT use an in line fuse on this line.
• Do NOT use accessory Power.
• To determine a switched power source:
1) Ensure the Driver Door is OPEN
2) Select a wire
3) W ith engine OFF, use voltmeter to measure the DC voltage on the wire. It should show 0 VDC.
4) S tart the engine and confirm that the voltage of the same wire is 13.1 VDC or higher
5) Turn the vehicle's engine OFF and confirm that the voltage of the same wire is 0 VDC
Constant Power (Battery)
Switched Power
Red Wire
Black Wire
Blue Wire
Networkfleet Unit
Ground
Advertisement
Table of Contents
