Billion M500 User Manual page 57


Wireless Client
When Wireless Client is selected, the router will act as an ordinary wireless client to connect to an AP
to connect to the Internet.
Status: Choose Activated to enable the Wireless Client connection.
ISP Connection Type:
ISP: Select the encapsulation type your ISP uses.
 Dynamic IP: Select this option if your ISP provides you an IP address automatically.
 Static IP: Select this option to set static IP information. You will need to enter in the Connection
type, IP address, subnet mask, and gateway address, DNS, provided to you by your ISP. Each
IP address entered in the fields must be in the appropriate IP form. IP address from by four IP
octets separated by a dot (xx.xx.xx.xx). The Router will not accept the IP address if it is not in
this format.
IP Common Options
Default Route: Select Yes to use this interface as default route interface.
IPv4 Options
NAT: Select Enable if you use this router to hold a group of PCs to get access to the internet.
Wireless Options
SSID: The target wireless AP. User can alliteratively input the SSID manually or also use the Scan
button to scan and select.
Channel: Choose the wireless working channel
Security Type: Set the wireless security mode, namely, OPEN, WEP 64-bit, WEP 128-bit, WPA-PSk
and WPA2-PSK.
53