Setting Jumpers - Aaeon HSB-810A Manual

H a l f - size CPU Card
CN4
CN5
CN3
CN6

2.6 Setting Jumpers

You configure your card to match the needs of your application by
setting jumpers. A jumper is the simplest kind of electric switch. It
consists of two metal pins and a small metal clip (often protected by
a plastic cover) that slides over the pins to connect them. To "close"
a jumper you connect the pins with the clip.
To "open" a jumper you remove the clip. Sometimes a jumper will
have three pins, labeled 1, 2 and 3. In this case you would connect
either pins 1 and 2 or 2 and 3.
A pair of needle-nose pliers may be helpful when working with
jumpers.
If you have any doubts about the best hardware configuration for
your application, contact your local distributor or sales
Chapter 2 Quick Installation Guide
PS2 Keyboard/Mouse Connector
Internal Keyboard Connector
LVDS Channel Connector
LAN 1 Active LED Connector
Open
H S B - 8 1 0 A
Closed
3
1 2
Closed 2-3
2 - 7