Advertisement
3-4. Auto Scroll ON or OFF – New with Model TZT9/14/BB v3.12
The TZT9/14/BB v3.12 program has another new setting option of Auto Scroll, which enables to scroll the Plotter, Radar,
and Sounder screen by placing a cursor at the edge of the screen. The following screenshots show the menu settings and
scroll motions.
Menu Settings
[Menu] – [General] – [Auto Scroll] – [ON]
In this example, a cursor is placed at the left edge of the
Plotter screen, while the chart is automatically scrolled.
(You can see the [Center Vessel] icon.) To stop the scroll
motion, place the cursor away from the edge.
3-5. Entering a Point
– New with Model TZTBB and TZT14 (External Touch Screen Mode) v3.12
Pushing the MCU002 joystick, [New Point] will be highlighted at default on the contextual menus. You can just press
[ENT] to enter the point.
Note:
This specification is for the TZTBB and TZT14 under the
[Menu] – [General] – [Auto Scroll] – [OFF] (Default)
At default, the Auto Scroll mode is set to OFF. When a cursor
is placed at the edge of the screen, the chart is not scrolled.
External Touch Screen Mode
Menu Settings
only. With the TZT9 and TZT14
10
Advertisement
