Memory Switch List - Brother MD-602 Service Manual

17. Memory switch list

Display No. SW
ON Parameter setting change enabled (Parameter setting mode can be entered)
01
OFF Parameter setting change disabled (Parameter setting mode cannot be entered)
ON No interlock during thread trimming
02
OFF No interlock during thread trimming (Invalid)
ON Momentary drop or failure of power supply check valid
03
OFF Momentary drop or failure of power supply check (lnvalid)
ON SBT speed and EBT speed (No relation with high speed setting)
04
OFF SBT speed and EBT speed (No more than of high speed setting)
ON (Not used)
05
OFF *Normally OFF
ON No penetration force UP operation
06
OFF Penetration force UP operation
ON (Not used)
07
OFF * Normally OFF
ON (Not used)
08
OFF * Normally OFF
Thread trimming validity setting enabled (F-operation panel is connected)
ON
* [
1 1
Thread trimming validity setting disabled (Treadle repression always includes thread
OFF
trimming)
Presser lifter rise after thread trimming when the treadle is neutral
(In the case of SW1-1 ON)
ON
Presser lifter descent after thread trimming when the treadle is neutral
(In the case of SW1-1 OFF)
1 2
Presser lifter descent after thread trimming when the treadle is neutral
(In the case of SW1-1 ON)
OFF
Presser lifter rise after thread trimming when the treadle is neutral
(In the case of SW1-1 OFF)
ON Presser lifter rise after neutral stop when the treadle is neutral stop.
1 3
OFF Presser lifter descent after neutral stop when the treadle is neutral stop.
ON (Not used)
1 4
OFF * Normally OFF
ON Normally is deceleration
1 5
OFF Quick stop is deceleration
ON No over time [o t] function
1 6
OFF Over time [o t] function (By a continuous 3 minutes stop)
[ ] OFF, Actuator switch = Half stitch correction switch
ON
[ ] ON, Actuator switch = 1 stitch correction switch
1 7
[ ] OFF, Actuator switch = Normally switch
OFF
[ ] ON, Actuator switch = 1 stitch correction switch
[ ] OFF, Actuator switch = Reverse stitch correction switch
ON
[ ] ON, Actuator switch = 1 stitch correction switch
1 8
[ ] OFF, Actuator switch = Normally switch
OFF
[ ] ON, Actuator switch = 1 stitch correction switch
42
] ON enabled, [ ] OFF not enabled
MD-602, 612
* The shaded fields indicate the default values.
Item & Contents