Control Box Dip Switch Setting Procedure - Brother MD-602 Service Manual

7.4 Control box DIP switch setting procedure

Wait at least 5 minutes after turning off the power switch before opening the cover of the control box. Touching
areas where high voltages are present can result in severe injury.
Do not clamp the cords inside the control box when closing the control box cover.
• Make sure that the DIP switches are set correctly, otherwise incorrect operation may result.
w
14
WARNING
CAUTION
Hazardous voltage Hochspannung Un voltage non adapté Un voltaje inadecuado
will cause injury. verletzungsgefahr! provoque des blessures. puede provocar las
heridas.
Turn off main Bitte schalten sie den Eteindrel'interrupteur et
switch and wait 5 hauptschalter aus und attendre 5 minutes Apagar el interruptor
minutes before warten sie 5 minuten, avantd' ouvrir le capot principal y esperar 5
opening this cover. bevor sie diese minutos antes de abrir
abdeckung öffnen. esta cubierta.
e
q
• Disconnect the synchronizer cord q.
• Loosen the two screws w, and then gently pull the
cover e toward you to open it.
• Set the DIP switches.
Refer to the tables for details of DIP switch functions.
• Close the cover e (be careful not to clamp the cord)
and tighten the two screws w.
• Connect the synchronizer cord q.
MD-602, 612