5.2 Power Distribution System
The power distribution subsystem consists of the hardware listed in the following table. It distributes 24 VDC
from a power system to one or more columns of mounting plates in one or both sides of a cabinet that contains
the power system.
The following hardware requirements are prerequisites for the power distribution subsystem.
•
The power system mentioned in the Selecting Power System section.
•
Two header boards (51307186)
•
Select power cables greater than or equal to 16AWG for AC. Maximum current of the header board is 20 A
See illustration below for more information:
Figure 3: Cabling for the power distribution subsystem
5 POWER SUPPLY SELECTION AND DISTRIBUTION
23