Installation Checklist; Post-Installation Checklist - Air Lift LoadLifter 5000 Ultimate Installation Manual

 Clearance test — Inflate the air springs to 40-50 PSI (2.8-3.4BAR) and make sure
 Leak test before road test — Inflate the air springs to 40-50 PSI (2.8-3.4BAR) and
 Heat test — Be sure there is sufficient clearance from heat sources, at least 6"
 Fastener test — Recheck all bolts for proper torque.
 Road test — The vehicle should be road tested after the preceding tests. Inflate the
 Operating instructions — If professionally installed, the installer should review the
 Overnight leak down test — Recheck air pressure after the vehicle has been used
 Air pressure requirements — It is important to understand the air pressure
 Thirty-day or 500-mile (805km) test —Recheck the air spring system after 30 days
18

INSTALLATION CHECKLIST

INSTALLATION CHECKLIST
INSTALLATION CHECKLIST INSTALLATION CHECKLIST
there is at least 1/2" (13mm) clearance from anything that might rub against each
sleeve. Be sure to check the tire, brakes, frame, shock absorbers and brake cables.
check all connections for leaks. All leaks must be eliminated before the vehicle is
road tested.
(152mm) for air springs and air lines. If a heat shield was included in the kit, install it.
If there is no heat shield, but one is required, call Air Lift customer service at
(800) 248-0892.
springs to recommended driving pressures. Drive the vehicle 10 miles (16.1km) and
recheck for clearance, loose fasteners and air leaks.
operating instructions with the owner. Be sure to provide the owner with all of the
paperwork that came with the kit.

POST-INSTALLATION CHECKLIST

POST-INSTALLATION CHECKLIST
for 24 hours. If the pressure has dropped more than 5 PSI (.34BAR), then there is a
leak that must be fixed. Either fix the leak yourself or return to the installer for service.
requirements of the air spring system. Regardless of load, the air pressure should
always be adjusted to maintain adequate ride height at all times while driving.
or 500 miles (805km), whichever comes first. If any part shows signs of rubbing or
abrasion, the source should be identified and moved, if possible. If it is not possible
to relocate the cause of the abrasion, the air spring may need to be remounted. If
professionally installed, the installer should be consulted. Check all fasteners for
tightness.
LoadLifter 5000 Series
MN-1053