Configuring The Scvmm Fabric Workflow - Cisco Nexus 1000V Installing Manual

For microsoft hyper-v

Hide thumbs Also See for Nexus 1000V:

Troubleshooting manual (280 pages)

Configuration manual (96 pages)

Deployment manual (49 pages)

Table Of Contents

Table of Contents

Chapter 1

Installing the Cisco Nexus 1000V for Microsoft Hyper-V

Create a VLAN inside the Network Segment using the command switchport access vlan <number>,

Step 9

for example, switchport access vlan 100.

Step 10

Associate the Network Segment Pool to the Network Segment using the command member-of network

segment pool <name>, for example, member-of network segment pool IntranetSJ.

Step 11

Import the IP pool template to the Network Segment using the command ip pool import template

<name>, for example, ip pool import template pool10.

Publish the Network Segment using the command publish network segment <name>, for example,

Step 12

publish network segment VMNetworkA. Type exit.

Create a virtual Ethernet port profile of type vethernet using the command port-profile type vethernet

Step 13

<name>, for example, port-profile type vethernet Veth-policy.

Enter the no shutdown command to keep the system in a power-on state. Enter state enabled at the

Step 14

prompt.

Publish the port profile using the command publish port-profile and type exit. The port profile is

Step 15

imported for publishing the Network uplink.

Create a virtual Ethernet port profile of type ethernet using the command port-profile type ethernet

Step 16

<name>, for example, port-profile type ethernet UplinkNoPortChannel.

Enter the no shutdown command to keep the system in a power-on state. Enter state enabled at the

Step 17

prompt.

Create a Network Uplink using the command nsm network uplink NexusUplink.

Step 18

Associate the Network Segment Pool using the command allow network segment pool IntranetSJ, for

Step 19

example, allow network segment pool IntranetSJ.

Import the port profile that was created earlier using the command import port-profile <name>, for

Step 20

example, import port-profile eth-pp-policy.

Step 21

Publish the Network Uplink using the command publish network uplink <name>, for example,

publish network uplink NexusUplink. Type exit.

Copy the running configuration to the start-up configuration using the copy running-config

Step 22

startup-config command. The following message is displayed in the window: Copy complete, now

saving to disk (please wait)

Enter the show running-config command to verify the configuration.

Step 23

The setup script configures the VSM to function in L3 control mode. L2 control mode is not supported

Note

with Cisco Nexus 1000V for Microsoft Hyper-V. When configuring L3 control with Microsoft Hyper-V,

you do not need to create a port profile with capability L3control. The VSM communicates with the

Microsoft Server 2012 management interface directly. There is no need to create a special vEthernet port

profile to be assigned to the Windows 2012 host.