(1.5 ft) from magnetic data carriers (floppy disks, audio and video tapes, bank cards, etc.) is sufficient; a distance of more than 1 m (3 ft) may be necessary with computer and video monitors. MAX Manual (5.0EN) Safety instructions MAX Manual (5.0EN)
Page 4
Connections The MAX cabinet is fitted with two EP5 connectors. All pins of both connectors are wired in parallel. Using one connector as the input, the second connector allows for direct connection to additional cabinets.
Page 5
4-wire operation (standard wiring EP5 and NL4) To allow the choice of active or passive operation the MAX cabinet is driven by a 4-wire cable. The HF and LF drivers are each fed by passive crossover their own pair of pins and separate passive crossovers. Pin assignments 1/2 of the EP5 connectors (NL4: 1+/1–) connect the LF...
Operation with D12 The D12 with the MAX set up selected, allows the MAX cabinet to be driven either in a 2-Way Active mode or in a Passive mode. MAX cabinets can also be operated with the Linear set up of D12 and E-PAC amplifiers.
Page 7
LCD. Selecting the MAX set up enables a single MAX cabinet to be driven at an output power of 300 Watts. LO IMP mode allows the E-PAC to drive two MAX cabinets with a 6 dB reduction of input level to the loudspeakers.
Page 8
When the MAX cabinet is used without an active subwoofer selecting LFC (Low Frequency Compensation) extends the low Controls on ampMAX module frequency response of the MAX cabinet down to 75 Hz. In active mode only the channel A LFC switch is functional. Active operation ("2-Way Active") The ampMAX module contains a switchable electronic crossover 1–...
4 to 10 kHz. MAX isobar diagram Frequency response The diagrams below shows the different response curves for MAX driven with the D12 amplifier. The response in standard mode with the Linear set up selected, is equivalent to the operation with a linear power amplifier (SPL at a distance of 1 m (3.3 ft), output...
Polarity to controller INPUT (XLR pin 2: + / 3: –) ........LF: + / HF: + MAX loudspeaker Frequency response (–5 dB, MAX set up) ..........55 Hz - 18 kHz Frequency response (–5 dB, Linear set up, free field)......85 Hz - 18 kHz Sensivity (2.83 V / 1 m) ...................
EU conformity of loudspeakers This declaration applies to loudspeakers manufactured by d&b audiotechnik AG and includes the types listed in the table below: − MAX Z1100 All production versions of these types are included, provided they correspond to the original technical version and have not been subject to any later design or electromechanical modifications.