2. Hardware Installation
This chapter will guide you through how to install the ALH-316ds/324ds. It
includes procedures for installing the hub on your working surface,
connecting the hub to your computer, and guidelines to see if it works well.
Before setting up your hub, please take note of the front and rear panel of
this hub, as shown in Figure 2-1 and 2-2.
Figure 2-1 Front panel
Figure 2-2 Rear Panel
Before installing the hub, you have to find a solid working surface to place
the hub and make sure the equipment is not close to any high voltage
power source or over-heated sources. Also keep away from electronic
equipment sensitive to electronic interface. The brief procedures of
installing your hub should be as following section: