AEG BCK45631PM User Manual page 31

1
2
Install the removed accessories in the
opposite sequence.
The retaining pins on the
telescopic runners must
point to the front.
10.4 Catalytic fan cover
CAUTION!
Do not clean the catalytic
surface with oven sprays,
abrasive cleaning agents,
soap or other cleaning
agents. This will damage the
catalytic surface.
Before you activate the
catalytic cleaning remove all
the accessories from the
oven.
The fan cover with a catalytic coating is
self-cleaning. It absorbs fat which collects
on the walls while the appliance
operates.
To support the self-cleaning procedure,
heat the empty oven on a regular basis.
1. Clean the oven floor with warm water
and washing up liquid, then dry it.
2. Set the function
3. Set the oven temperature to 250 °C
and let the oven operate for 1 hour.
4. When the oven is cool, clean it with a
soft and wet sponge.
Spots or discolouration of the catalytic
surface have no effect on catalytic
properties.
.
10.5 Oven ceiling
WARNING!
Deactivate the appliance
before you remove the
heating element. Make sure
that the appliance is cold.
There is a risk of burns.
Remove the shelf supports.
You can fold down the heating element
on the oven ceiling to clean the oven
ceiling easily.
1. Hold the heating element with two
hands at the front.
2. Pull it forwards against the spring
pressure and out of two holders.
The heating element folds down.
3. Clean the oven ceiling.
4. Install the heating element in the
opposite sequence.
Install the heating element
correctly above the supports
on the inner walls of the
appliance.
5. Install the shelf supports.
10.6 Removing and installing
the door
You can remove the door and the
internal glass panels to clean it. The
number of glass panels is different for
different models.
WARNING!
The door is heavy.
1. Open the door fully.
2. Fully press the clamping levers (A) on
the two door hinges.
ENGLISH 31