Table of Contents
Advertisement
IP Address Setting(SW1~3 Operation):
Before using the node, please set the existing E-NODE 8's IP addressing from 172.16.0.[0]~172.16.0.[255] by
using SW1~SW3 as you desired. As per E-NODE 8, 172.16.0.0, 172.16.0.3, 172.16.0.255 are not available.
Special Notice:
1.
When A*100+B*10+C exceeds 255, the IP address of the node will be set to 172.16.0.250 automatically.
2.
After you change the protocol setting and IP address setting by using any dip-switch, please disconnect
the main power to confirm your setting. Then connect the main power and restart your device.
3.
It is strongly recommended that the amount capacity of 200,000 pixels controlled over distributed by the
entire holding system of one computer is allowed.
SW1
Set IP:
[0~255]=
A*100+B*10+C
A=0~2
B=0~9
C=0~9
-6-
SW2
SW3
Advertisement
Table of Contents
