Table of Contents
Advertisement
E.4
Default configuration on the wide area network side
WAN characteristics
ATM characteristics
Note: The OAM functions provided are as follows:
- Segment and end-to-end flow F4 and F5 management by VC.
- AIS/RDI functions.
- Response to loopback cells F4 or F5.
- Response to continuity check (CC) enable/disable cells.
PPP characteristics
Remote Management
ADSL characteristics
Note: The user can revert to the default configuration via the HTTP interface.
E.5
Default configuration for advanced functions
Advanced functions
characteristics
Reproduction and communication prohibited without the written permission of E
Function - Mode
Protocol
VPI
VCI
Encapsulation
QoS Class
PCR
SCR
MBS
NAT
Default route
DNS relay
Firewall
Intrusion detection
OAM F4 and F5 (see Note)
IP address
MTU
Connect Type
Access
Maximum upstream rate
Maximum downstream rate
Mode
Latency
Function - Mode
UPnP
DDNS
SAGEM F@st™ 1500 Reference Manual - 288053220-04
Appendix E - Default configuration
State/Value
PPPoA
8
35
VC MUX
UBR
4000 cells/s
4000 cells/s
10
Enabled
ADSL interface address
Enabled
Enabled
Disabled
Enabled
Automatic negotiation
1400
Always Connected
Disabled
896 kbit/s
8160 kbit/s
Multimode
Simple latency (fast or interleaved)
State/Value
Enabled
Disabled
E
E
E
Page E-3
Advertisement
Table of Contents
