Chamberlain KPR2000 Installation Setup Manual page 12

INTRODUCTION
SET RELAY CONFIGURATION
The relay configuration sets the behavior of the output relay on activation.
Programming Step
1. Enter Program Mode
2. Pulse Mode (Default)
OR
2. Latch Mode
3. Exit Program Mode
SET WIEGAND INPUT/OUTPUT OPTIONS
The KPR2000 offers input and output for industry standard Wiegand devices
(refer to Specifications). Default is HID 26 bit.
Programming Step
1. Enter Program Mode
2. Set Wiegand Format
3. Exit Program Mode
INSTALLATION
Keystroke Combination
✱ (Master Code) #
4 (1-99) # The relay time is 1-99 seconds
4 0 # Sets the relay to ON/OFF latch mode
✱
Keystroke Combination
✱ (Master Code) #
9 (Bit Format) # Bit Format = Valid 2 digit
format (example: 26 or 30)
✱
12
WIRING
(default is 5 seconds)
SET UP