Chamberlain KPR2000 Installation Setup Manual page 18

INTRODUCTION
CHANGE A PIN
Allows card user to update a previously set PIN for a card & PIN or card + PIN User
ID. Default PIN codes (1234) can only be changed by using Change PIN using a card.
NOTE: This operation is executed from outside of Program Mode.
Programming Step
1. Change a PIN using a Card
OR
1. Change PIN using PIN
NOTE 1: When assigning a user both a card and a PIN, the card MUST be assigned
first. After the card is assigned, the user must change the PIN using card to activate
the PIN for this user. If the PIN is assigned first, a second user ID must be used to
assign the card.
NOTE 2: When adding or deleting multiple users sequentially, the program command (1
or 2, respectively) is entered only once at the beginning of the procedure. For additional
users, enter the user ID and credentials only in the same order as the first entry. When
sequence is complete, programming step is terminated by pressing ✱ once.
EXAMPLE: To Add Multiple Users
Programming Step
1. Enter Program Mode
2. Add multiple users
3. Exit Program Mode
INSTALLATION
Keystroke Combination
✱ (Read Card) (Old PIN) # (New PIN)
# (New PIN) #
✱ (User ID) # (Old PIN) # (New PIN)
# (New PIN) #
Keystroke Combination
✱ (Master Code) #
1 (User ID 1) # (PIN1) #,
(User ID 2) # (PIN2) #,
(User ID 10) # (PIN10) #
✱ ✱
18
WIRING SET UP