Chamberlain KPR2000 Installation Setup Manual page 16

INTRODUCTION
ACCESS CONFIGURATION: CARD OR PIN, CARD + PIN, & CARD ONLY
ADD USER CARD(S)
Programming Step
1. Enter Program Mode
2. Add Card: Using Auto ID (Allows
KPR2000 to assign Card to next
available User ID number)
OR
2. Add Card: Select Specific ID (Allows
manager to define a specific User ID
to associate the card to)
OR
2. Add Card: Block Learn (Allows
manager to add up to 2000 cards to
the KPR2000 in a single step †).
Takes 2 minutes to program.
3. Exit Program Mode
† Block Learn Direct Entry
INSTALLATION
Keystroke Combination
✱ (Master Code) #
1 (Read Card) #
Repeat Step 2 for additional user
cards. See Notes 1 and 2.
1 (User ID) # (Read Card) #
See Notes 1 and 2.
5 (User ID) # (The first card number)
# (Card Quantity) #
Card quantity = number of cards to be
enrolled
✱ ✱
Format for programming specific Card
Numbers: Facility Code + Serial
Number (including leading 0's)
Example: FAC- 24, SN- 100 would be
entered as:
26 Bit: 02400100
30 Bit: 0000000100
Only the Serial Number is validated for
30 bit cards.
16
WIRING SET UP