Chamberlain KPR2000 Installation Setup Manual page 17

INTRODUCTION
DELETE USER CARD(S)
Programming Step
1. Enter Program Mode
2. Delete Card - By User ID
OR
2. Delete Card - By Card
OR
2. Delete Card -By Card Number
3. Exit Program Mode
† Block Learn Direct Entry
ADD OR DELETE A PIN
A PIN may be programmed to a separate or an existing user ID. PINs programmed
separately will use additional memory.
Programming Step
1. Enter Program Mode
2. Add a PIN
Assigns PIN to user ID number
OR
2. Delete a PIN
Deletes the User ID number and
associated PIN
3. Exit Program Mode
INSTALLATION
Keystroke Combination
✱ (Master Code) #
2 (User ID) #
Deleting by User ID number will clear
cards and PINs
2 (Read Card) #
Requires the user card. Deletes ONLY the
card number
2 (Card Number) #
Deletes ONLY the card number †
✱ ✱
Format for programming specific Card
Numbers: Facility Code + Serial Number
(including leading 0's) Example: FAC- 24,
SN- 100 would be entered as:
26 Bit: 02400100
30 Bit: 0000000100
Only the Serial Number is validated for
30 bit cards.
Keystroke Combination
✱ (Master Code) #
1 (User ID) # (PIN) #
Repeat Step 2 for additional PINs
See Notes 1 and 2.
2 (User ID) #
Repeat Step 2 for additional PINs
See Notes 1 and 2 on the following page.
✱ ✱
17
WIRING SET UP