INTRODUCTION
RESET THE KPR2000
This will reset the KPR2000 to the factory default but all card/PIN information will
still be retained. This will also require reprogramming of the Master Add and
Delete Cards. NOTE: This is useful if the original Master Add and Delete Cards
have been lost.
Programming Step
Reset the KPR2000 to
the factory default
ERASE ALL CODES
Programming Step
Delete ALL User data
INSTALLATION
Keystroke Combination
1. Power the KPR2000 down.
2. Press and hold the ✱ button while power is
restored to the KPR2000.
3. Release the button and wait until the amber LED
shines.
4. Present any 26 bit proximity card or the Manager
Add Card (provided) to the KPR2000. This card is
now the Manager Add Card.
5. Present any 26 bit proximity card or the Manager
Delete Card (provided) to the KPR2000. This card
is now the Manager Delete Card.
When the red LED begins to blink, the KPR2000 has
been successfully reset.
Keystroke Combination
1. Enter Program Mode by pressing: ✱ (Master
Code) #.
2. Press 2 0000 #.
3. Exit Program Mode by pressing: ✱ ✱
All configuration data is retained.
21
WIRING
SET UP