Table of Contents
Advertisement
6
Configuration
6.1.2
Labels
Start menu.
Select Setup > Labels.
Parameter
Label sensor
Extrapolate labels
Parameters of the Setup > Labels menu
Table 6
6.1.3
Ribbon
Start menu.
Select Setup > Ribbon.
Parameter
Transfer print
Warn level ribbon
Pause on warning
Monitor ink side
Parameters of the Setup > Ribbon menu
Table 7
i5100 Configuration Manual
Meaning
Method for detecting the starting end of the label.
Gap Sensor: Detection using changes in the transparency between the
label and label gap.
Bottom-Reflect: Detection using reflex marks on the bottom of the medium.
Continuous media: Checking the existence of media only.
The positions of the labels which are between the label sensor and the
printhead are calculated from the first label recognized by the sensor
and the programmed label distance. That way those labels can be
printed although the printhead previously was open.
Meaning
On: Sensor for monitoring the transfer ribbon is activated.
Off: Sensor for monitoring the transfer ribbon is not activated.
The setting can be overwritten for each print job via software. The basic
setting is not changed by this.
Threshold diameter (32–74 mm) of the ribbon supply roll, if the value is
undershot the "ribbon low" message will be activated
The print job will be interrupted when the "ribbon low" message appears
Setting of the ribbon unwinding direction
The print job will be interrupted when the wrong ribbon winding direction
has been detected. The error message "Ribbon ink side" appears.
Default
Gap sensor
Off
Default
On
Off
Off
Off
19
Hide quick links:
Advertisement
Table of Contents
