Table of Contents
Advertisement
8
Diagnostic Functions
8.3
Label Profile
The Label profile function carries out a longer label advance. It saves the values measured by the label sensor here and
then prints them out in a diagram.
The printout is used to check label detection in conjunction with the optical properties of the label medium.
The printout occurs using the heat level and print speed specified in the Setup > Printing menu.
i
Notice!
The printout occurs without taking the label gaps into consideration. This is why endless media are most
suitable for this purpose.
Select the label sensor to be tested in the Setup > Labels menu page 19.
Load the label medium to be tested into the printer.
Start menu.
Select Diagnostics > Label profile.
The printer performs a longer label advance. The label sensor measures the transparency/reflection capacity of the
label material here. The message Insert appears in the display once the advance is complete.
Insert printable medium (labels, endless paper) which extends across the entire printing width.
If the printout is to occur using thermal transfer printing, insert transfer ribbon with the maximum width.
Start the diagram printout with Continue.
The printout can be canceled with
Tue Feb 13 13:51:19 2018
1
Brady i5100-300
Firmware V5.14 (Feb 09, 2018) - #164162032326
2
3
Gap Sensor - 50 mm/s - Brightness 109
4
71.74mm - σ² 0.014mm²
Figure 20
Label profile
No.
Information
1
Date and time of the printout
Device type
Version and creation date of the firmware
Serial number of the PCB CPU
Firmware version and serial number of the label sensor
2
Coordinate in the direction of paper flow at which the label start was detected
3
Print speed, method of label detection (Gap sensor / Bottom-reflect sensor)
Brightness of the sensor LED during the measurement
4
Average value and variation of label distances
Table 25
Information in Label profile
i5100 Configuration Manual
.
Label profile
41
Hide quick links:
Advertisement
Table of Contents
