Table of Contents
Advertisement
6
Configuration
6.1.4
Tearing-off
Start menu.
Select Setup > Tearing-off.
Parameter
Tear-off mode
Tear-off position
Parameters of the Setup > Tearing-off menu
Table 8
6.1.5
Cutting
If cutter is not installed, access only with service key inserted.
Start menu.
Select Setup > Cutting.
Parameter
Cut position
Parameters of the Setup > Cutting menu
Table 9
6.1.6
Peeling-off
If peel-off module is not installed, access only with service key inserted.
Start menu.
Select Setup > Peeling-off.
Parameter
Peel-off position
Backfeed delay
Table 10
Parameters of the Setup > Peeling-off menu
20
Meaning
Positioning the label medium for tearing off at the tear-off plate.
On: Additional advancement of the label medium which positions the
label gap after the last printed label at the dispense plate.
Off: Label advance stops once the last label has fully passed the print
line.
Shifting of the tear-off position in the direction of paper flow. With
positive values, the label strip is transported farther out of the printer.
Meaning
Offset of the cut position relative to the rear label edge.
The setting can also be adjusted by the software.
The settings of configuration and software are added together.
Meaning
Shift the position of the dispensed label relative to the dispensing edge.
The setting can also be adjusted by the software.
The settings of configuration and software are added together.
Delay time between removing the label from the peel position and the
backfeed of the label.
Default
On
0.0 mm
Default
0.0 mm
Default
0.0 mm
250 ms
i5100 Configuration Manual
Hide quick links:
Advertisement
Table of Contents
