Banner MSDINT-1L2 Instruction Manual

The enclosed MINI-SCREEN controller
MSDINT-1, MSDINT-1L2, or replacement
board reflect the new MINI-SCREEN DIN
controller design. These controllers are
identical to the old MINI-SCREEN DIN
controller, except that they have
removeable wiring blocks. With the
removeable wiring blocks, wiring terminal
numbers change and one overall
controller dimension increases. This
supplement modifies the information for
figures 17, 20, and 23, which appear in
MINI-SCREEN manual 44895.
Printed in USA
MINI-SCREEN Controller Models
MSDINT-1 and MSDINT-1L2
Supplement to MINI-SCREEN Instruction Manual 44895
100.0 mm
(3.94 ")
85.3mm
7.4 mm
(3.36")
(0.29")
60.8 mm
(2.40")
DIN Mounting Tab
7.1 mm
(Supplied)
(0.28")
Figure 17. Control Module Dimensions and Mounting Hole Locations.
SSD
18 19
MINI-SCREEN
MSDINT-1 or 1L2
MODEL NO.
LISTED
Presence
Sensing
Device
10Y8
1 2 3 OK
Diagnostic
Chart on
Reverse Side
1 2
Test 1
AUX
or
LATCH
ALARM
RESET 1
Figure 20. MINI-SCREEN System electrical connections.
04/00
110.0 mm
(4.33")
Combo Head (Phillips/Slotted) Screws
M3.5 x 0.6 mm x 14 mm (2) (#6 x 0.5" equivalent) (Supplied)
M3.5 mm Washers (2) (#6 equivalent) (Supplied)
M3.5 mm x 0.6 mm Nuts (2) (36 equivalent) (Supplied)
Recommended torque is 16 in-lbs on mounting screws
35.0 mm
(1.38")
DIN Mounting Slot
Slot for Screws (2)
M3.5 x 0.6 mm (2)
FSD2 FSD1
22 23 27 28
!
CAUTION
Shock hazard may exist.
operation always follow the
Blocked or Latched
0466
Reset
STEADY
BANNER ENGINEERING CORP., USA
4 5 8 9 13
Test 2 Key 1 Key 2 +12V
or or dc
LATCH
RESET 2
83.8 mm
(3.30")
+24 dc PE
V dc Com
32 33 34
WARNING
For control reliable
instructions in the manual.
Lockout
Clear Blanking
Alignment
FLASHING
(612) 544-3164
14 15 16 17
COM T/R T/R DRAIN
P/N 62875