Table of Contents
Advertisement
3
Faults and what to do
about them
E mergency release, e.g. if a
F a u l t s a n d w h a t t o d o a b o u t t h e m
power failure occurs
The programme continues running
when the power supply is restored. If
the washing is still to be removed, the
door can be opened as described
below:
:
Warning
Risk of scalding!
When washing at high temperatures,
you may be scalded if you touch hot
washing water or the laundry.
If required, leave to cool down.
:
Warning
Risk of injury!
If you reach into the rotating drum, you
may injure your hands.
Do not reach into the rotating drum.
Wait until the drum stops rotating.
Information on the display panel
Display
A:01
A:02
A:03
Cause/Remedy
Close the door immediately because of the rising water level. If an interruption
occurs, A:01 and OPEN are displayed alternately.
The door is locked for safety reasons (water level and/or temperature too high).
Washing programme: In pause mode A:02 and PAUS are displayed alter-
■
nately. If you have to open the door, wait until the temperature has dropped
slightly or pump out the water (select e.g. 0 Spin or Drain [).
Drying programme: If you have to open the door, wait until the temperature
■
has dropped slightly or set the drying programme to 15 min to cool down the
laundry.
If A:02 is frequently displayed at the end of the drying programme:
Clean the air filter. ~ Page 44
■
Run the Drum Clean l Ž (cold) programme without laundry.
■
Door cannot be locked/unlocked due to high temperature. Leave the washer
dryer switched on for about 1 min. The washer dryer can then be locked/
unlocked again.
Faults and what to do about them
Caution!
Water damage
Leaking water may cause damage.
Do not open the door if you can still see
water through the glass.
Turn the programme selector to
1.
Ú Off. Pull out the mains plug.
Drain the detergent solution.
2.
Pull down emergency release with
3.
a tool and release.
Door can then be opened.
en
45
Advertisement
Table of Contents
