Table of Contents
Advertisement
Changing programme default settings
en
Starching
The laundry should not be
Note:
treated with fabric softener.
Liquid starch can be used in all wash
programmes. Pour starch into the
dispenser M according to
manufacturer's specifications
(if required, clean beforehand).
Dyeing/Bleaching
Dye in household quantities only. Salt
may attack stainless steel! Observe
specifications of the dye manufacturer!
Do not bleach laundry in the washer
dryer!
Soaking
Pour soaking agent/detergent into
1.
dispenser II according
to the manufacturer's instructions.
Set the programme selector to
2.
Cottons 60°C and select Start/
Reload A.
After approximately 10 minutes
3.
select Start/Reload A.
After the required soaking time,
4.
reselect Start/Reload A if the
programme is to be continued or
change the programme.
Note:
Load laundry of the same colour. No
additional detergent is required,
the soaking solution is used for
washing.
38
0
Changing programme
default settings
Y ou can change the default settings for
C h a n g i n g p r o g r a m m e d e f a u l t s e t t i n g s
selected programmes. The settings can
be changed even while the selected
programme is running.The effects
depend on the progress of the
programme.
°C (Temperature)
(: The indicated washing
temperature can be changed. The
maximum selectable washing
temperature varies depending on the
selected programme.
Overview of programmes ~ Page 34
0 (Finish in)
0: Delays the Finish in time (end
of programme).
Note:
The respective programme duration is
displayed by selecting the programme.
The programme duration is
automatically adjusted while the
programme is running if the programme
duration needs to be changed, e.g. due
to changes in the programme default
settings.
Before the programme starts, the end of
the programme can be preselected in
hourly increments up to a maximum of
24h.
When the programme has started,
the preselected time is displayed e.g.8h
and counts down until the programme
Advertisement
Table of Contents
