Faults
Spin result not satisfac-
tory.
Laundry wet/too damp.
Spin cycle activated sev-
eral times.
Residual water in the dis-
penser for care product.
Compartment M is not
rinsed out completely.
Odour formation in the
washer dryer.
Status display *
flashes. Foam may come
out of the detergent
drawer.
Excessive noise, vibra-
tions and "wandering"
during the spin cycle.
Display panel/indicator
lights do not function
while the appliance is
running.
The programme duration
changes during the wash
cycle.
Detergent residue on the
washing.
Spin noise during the dry-
ing phase.
Different coloured fluff
from the previous drying
cycle is deposited on the
laundry during the subse-
quent wash cycle.
Water inlet noise during
the drying phase, the tap
symbol flashes during the
drying phase.
Cause/Remedy
Not a fault – unbalanced load detection system has stopped the spin cycle,
■
washing unevenly distributed. Distribute small and large items of washing
in the drum.
Too low speed selected?
■
Not a fault – unbalanced load detection system adjusts imbalance.
Not a fault – effect of the care product not impaired.
■
If required, remove the insert. Clean the detergent drawer and re-insert it.
■
Remove the insert. Clean the detergent drawer and reinsert it.
Run the Drum Clean l 90°C programme without laundry.
■
Use standard detergent.
■
Too much detergent used?
Mix 1 tablespoon of fabric softener with ½ litre of water and pour into
■
dispenser II. (Not for outdoor, sports and down-filled textiles!)
Reduce detergent dosage for the next wash cycle.
■
Use commercially available low foam detergent and care products which
■
are suitable for washer dryers.
Appliance aligned? Align the appliance. ~ Page 18
■
Appliance feet fixed? Secure appliance feet. ~ Page 18
■
Transportation protection devices removed? Removing the transportation
■
protection devices ~ Page 15
Power failure?
■
Fuse tripped? Switch on/replace fuse.
■
If the fault occurs repeatedly, call customer service. ~ Page 49
■
Not a fault – unbalanced load detection system adjusts imbalance.
■
Not a fault – foam detection function active. Additional rinse cycle.
■
Occasionally phosphate-free detergents contain water-insoluble residue.
■
Select Rinse à or brush items when the laundry is dry.
■
This is an innovative process known as thermal spinning used to reduce energy
consumption during the drying phase.
Run the Drum Clean l Ž (cold) programme without laundry to remove fluff
which has collected in the washer drum during the drying phase.
The washer dryer runs a self-cleaning cycle to remove fluff which was deposited
by the laundry during the drying phase. This requires a little water. Therefore,
the tap must be turned on even during the drying phase.
Faults and what to do about them
en
47