Notch/Cutout Dimensions - Brady i5100 User Manual

Notch/Cutout Dimensions

for marginal cut-out marks
minimum liner thickness .002 in. (0.06 mm)
Callout
Label distance
A
Width of cut-out mark
N
Height of cut-out mark
P
Distance mark to middle of paper track
X
for gap sensor recognition
for reflective sensor recognition
Sensor recognized virtual label front edge
Y1
with reflective sensor recognition
Y2
with gap sensor recognition
Distance recognized front edge to actual label front edge
with reflective sensor recognition
Z1
with gap sensor recognition using transparent labels
Z2
> Adjust software settings
(1)
Backside of the material must be sufficiently reflective.
Marginal
notch/cut-out
BradyPrinter i5100
Labels with cut-out marks ("notches")
Description
Long hole
notch/cut-out
Continuous material with cut-out marks ("notches")
(1)
Rectangular
notch/cut-out
Dimensions
(>2 mm)
(>5 mm)
(2 - 10 mm)
(-10 or 0 mm)
(-56 up to +10 mm)
Front edge cut-out
Rear edge cut-out
P up to A
0 up to A-P
Circular Notch/Cut-out
notch/cut-out between labels
Not recommended
Not recommended
39