Brady i5100 User Manual page 34

Error Message
Invalid setup
Memory overflow
Multiple Label Tags
Found, Remove
Extras
Multiple Ribbon Tags
Found, Remove
Extras
Multiple Tags Read
Remove Extra Tags
Name exists
Network Error,
No Link
No label found
No label size
32
Cause
The Setup menu is incorrectly config-
ured.
Current print job contains too much
information, e.g. selected font, large
graphics.
Handshake mode is not on.
Multiple tags on core of IP-enabled
label material or printer did not clear
from last tag read.
Multiple tags on core of IP-enabled
label material or printer did not clear
from last tag read.
RFID tags on an IP-enabled roll of
labels read incorrectly.
Duplicate usage of field name in the
direct programming
Ethernet is selected in the setup
menu but no Ethernet connection.
There are labels missing on the label
material
The label format as set in the soft-
ware does not correspond with the
real label format.
Printer is loaded with continuous
paper, but the software is set on
labels
Missing RFID Tag
The size of the label is not defined in
the programming/software.
Corrective Action
Cancel the current job. Recheck all
configuration settings.
Cancel current print job.
Reduce amount of data to be printed.
Access the printer setup menu, hand-
shake mode and select RTS/CTS.
Reboot printer to get a fresh read of
supply. If error reoccurs select Enter
to bypass and use Standard mode.
Reboot printer to get a fresh read of
supply. If error reoccurs select Enter
to bypass and the printer will
load primary ribbon settings for Brady
mode.
Remove and reinstall the label spool
and/or the ribbon spool. If the error
does not clear, recycle power to the
printer.
Correct programming
Check that the Ethernet server is
available and connected, then recycle
power to the printer.
or
Go to the settings menu and turn off
Network Error reporting, then recycle
power to the printer.
Press Repeat repeatedly until printer
recognizes the next label on the
material.
Cancel current print job.
Change the label format set in the
software.
Restart print job.
Cancel current print job.
Change the label format set in the
software.
Restart the print job.
Select Enter to bypass error and use
in Standard mode.
Check the software programming.
BradyPrinter i5100