Honeywell VISTA User Manual page 13

WARNING: Automation is intended for lifestyle convenience. Do not use
automation for life safety and property protection.
1. Go to the Z-Wave Device Management screen
.
Setup)
2. Click the Add Device button.
3. At the Z-Wave device, press the appropriate Function button depending
on the type of device being added. Refer to the Device sections that follow:
A. Light, Switch or Outlet Devices
i. Perform steps 1 & 2 above.
ii. Be sure the power switch on the device module is ON.
iii. Press the Function Key on the device.
NOTE: Z-Wave light modules may vary; follow the instructions in
the User's Guide for your specific device to include properly into the
Z-Wave network.
• If a dimmer module (multi-level switch) was included, an On/Off
button and three lighting level buttons (Low, Mid, High) are
displayed.
• If an on/off light/appliance module (binary switch) was included,
an On/Off button (to control the device) is displayed.
The screen displays a series of messages:
"Start add device. Please press function key on device"
B. Door Locks and Garage Door Control Devices (Entry Controller)
Assemble the Z-Wave entry controller.
IMPORTANT: Be sure the door lock orientation/handedness is
correct before including the lock into the system.
NOTE: The VAM cannot synchronize panel users to the lock.
Door locking devices may vary; follow the instructions in the User
Guide for your specific door lock to include properly and to program a
new user code. Refer to the Door Lock's Instruction Guide and connect
necessary cables, then install batteries.
NOTES:
If software is upgraded on the VAM, re-include the door lock and
reset the user code in the door lock
Include a door lock device into VAM as follows:
i. Perform steps 1 & 2 above.
ii. Press the Function Key on the door lock.
(Automation > Z-Wave
"Adding Slave Unit"
"Device added successfully"
– 13 –