Lab.gruppen IPD 1200 Operation Manual page 30

15. Appendices
15.3. Technical specifications
Model - IPD 2400
General
Number of channels (not bridgable)
Maximum total output power
Output voltage
Output current
Max. Output Power (all ch.'s driven)
2 ohms
4 ohms
8 ohms
16 ohms
Performance
THD+N 20 Hz - 20 kHz @ 1 W
THD+N @ 1 kHz, 1 dB below clip
Output noise
Signal To Noise Ratio
Channel separation @ 1 kHz
Frequency response (-3 dB)
Input impedance
Common Mode Rejection (CMR)
Output impedance
Input sensitivity for maximum output voltage
Maximum analog input level
Gain (all DSP controls set to 0 dB)
Mains power
Nominal mains voltage
Operating mains voltage
Standby consumption
Mains connector
Physical
Dimensions (Rack rail - rear panel)
Dimensions (over all incl. handles & rear support)
Weight
Finish
Connectors
Analog input connectors per channel
Analog input link connectors per channel
AES input connector
AES input link connector
Output connectors per channel
Network connector
Buttons
Encoder
LED's
Approvals
All specifications are subject to change without notice.
30
IPD SERIES Operation Manual rev 2.0.0
2
2400 W
100 V peak / 70 Vrms / 39.2 dBu
20 Arms
800 W
1200 W
600 W
300 W
<0.1%
<0.05%
-66 dBu
105 dB
>80 dB
2 Hz - 42 kHz
18 kOhm
>50 dB
25 mOhm
6 dBu
20 dBu
33.2 dB
100 - 240 VAC
60 - 265 VAC
<7.5 W
Locking IEC inlet
W: 483 mm (19"), H: 44 mm (1 U), D: 359 mm (14.1")
W: 483 mm (19"), H: 44 mm (1 U), D: 431 mm (17.0")
6.2 kg (13.7 lbs)
Black, anodized aluminium front panel. Black/grey steel chassis
3-pin XLR female
3-pin XLR male
3-pin XLR female
3-pin XLR male
Neutrik speakON / Binding posts, electronically balanced
RJ45 (Ethernet)
Power
Menu
Back
Mute (per channel)
Power
Adjust/Set
Signal / Mute (per channel)
Limit (per channel)
Power State
CE, UL (ANSI/UL, CAN/CSA), PSE, RCM, CCC, FCC.