Electrical Installation; What This Chapter Contains; General Cabling Instructions; Connections Between The Components Inside The Rmde-01 - ABB RMDE-01 Product Manual

Electrical installation

What this chapter contains

This chapter describes the electrical installation procedure of the RMDE-01 reliability
monitoring device.

General cabling instructions

• Arrange the cables as far from the power cables as possible.
• Avoid parallel runs with the power cables.
• Do not route the data or antenna cables in the cable ducts inside RMDE-01 (no space
for external cables).
For information on cable types, see section

Connections between the components inside the RMDE-01

These connections are done by the manufacturer. Do not change the connections on site.
See chapter Circuit diagrams (page
line.

User connections

WARNING!
Only qualified electricians are allowed to do the work described in this section.
Read the complete safety instructions delivered with the drive before you install,
commission, use or service the drive or the reliability control enclosure.
Make these connections on the installation site:
• Sensor connection
Cable data (page
53). These connections are drawn in normal continuous
Electrical installation 23
4
49).