Start-Up; What This Chapter Contains; Configuring Sim Card Settings For The Modem; Changing Configuration In The Modem Using Sd Card - ABB RMDE-01 Product Manual

Reliability monitoring device

Table of Contents

Start-up

This chapter instructs how to start-up monitoring and how to secure the connected devices.

ABB pre-configures the cellular modem at the factory with these default settings:

•

PIN code - 1234

•

APN address - internet

•

3G connection operator specific username and password are empty

•

Forwarding of outgoing traffic from Ethernet ports (NETA-21 monitoring tools) to internet

instead of default settings to forward traffic only via Talk2M VPN.

WARNING!

The default factory configuration of the modem expects that the PIN code for the

SIM card is 1234. If you have another PIN code, then do not power on and off the

RMDE-01 and the cellular modem without doing the start-up setup after the first

power up of the RMDE-01. Three consecutive power cycles may lock the SIM card

if the PIN code is different than 1234 and start-up has not been done.

If you want to modify any of the above mentioned settings, import new configuration using

an SD card. The SD card can be taken from the NETA-21 module. Any SD/SDHC card of

size 2 GB to 32 GB can be used for the Cellular modem configuration.

￭

If the default settings are valid for the chosen operator and SIM card, then this step can be

skipped. However, if you need to change the settings, make the changes before inserting

the SIM card in the Cellular modem.

1. Create a configuration file (comcfg.txt) on SD card using a local computer.

Start-up 27

Table of Contents