Connecting Pc To Neta-21; Logging On To Neta-21 - ABB RMDE-01 Product Manual

Start-up 33
Note:
Setup wizard suggests to process internet settings. This is not required since the internet
configuration is already configured.
For further information on modem, see manufacturers document delivered with the product.

Connecting PC to NETA-21

The NETA-21 monitoring tool consists of two Ethernet ports. The ETH2 port is connected
through an Ethernet wire to the modem and has fixed IP address. See section Connecting
via Ethernet link (page 24). The ETH1/PC port is available for on-site access to the NETA-21
or to connect ACS880 drives using FENA-21.
The NETA-21 module can enable a DHCP server in the Ethernet1 network (PC ETH 1
terminal), which allows connecting a PC with automatic IP address settings.
To access NETA-21 in the DHCP mode, the PC must contain automatically assigned IP
address settings. The connection between the PC and NETA-21 ETH1 port needs to be
point to point.
￭

Logging on to NETA-21

1. Make sure that the RMDE-01 is power on.
2. Press and hold NETA-21 SD/RJ45 button for five seconds.
3. Connect an Ethernet cable between the NETA-21 ETH1 port and a PC.
4. Navigate to https://192.168.230.1.
5. Enter default Username and Password for the first time login.
• The default Username is admin and the Password is admin.
6. Change the Username name and Password after the first login.
After login, the system prompts with the NETA-21 license dialog. Click Close to exit the
license dialog.