Table of Contents
Advertisement
28 Start-up
Note:
You can download the configuration sample file from
2. Power on the Cellular modem.
3. Wait a minute so that the Cellular modem will start-up.
4. Place the SD card (with comcfg.txt file) in the modem SD card slot.
•
Within five seconds, the modem displays a slow blinking pattern of the USR LED.
After processing the SD card, the modem displays the result on the USR LED. Solid
green indicates a success and Solid red indicates a failure.
•
If the modem was configured previously with identical configuration, the LEDs do
not change their color during SD card processing. Installation step is still valid if the
connectivity testing is successful.
5. Remove the SD card.
•
The modem will reboot and apply the new settings.
Note:
In this special case, you must remove the SD card while the modem is power on.
6. After reboot all the Ethernet ports must show green. In case SIM card is configured, the
signal and ST LED must be in orange without blinking.
For further information on troubleshooting, see https://ewon.biz/.
ABB download
center.
Advertisement
Table of Contents
Troubleshooting
