System Diagnostics; Test Items; Startup And Exit Of System Diagnostics - NEC Express5800/R120f-1M Maintenance Manual

Chapter 1 Maintenance
8.

System Diagnostics

The System Diagnostics runs several tests on the server.
8.1

Test Items

The following items are tested in System Diagnostics
• Memory
• CPU cache memory
• Hard disk drive
8.2

Startup and Exit of System Diagnostics

Start up System Diagnostics in the following procedure. If the server is running, shutdown the system.
1. Start up EXPRESSBUILDER and select Tool menu from Boot menu.
For information on starting up EXPRESSBUILDER, see Chapter 2 (5. Details of EXPRESSBUILDER).
2. Select Test and diagnostics.
3. Select End-User Mode (Basic) to start System Diagnostics. This process takes about three minutes.
When the diagnostics is completed, the screen display changes as shown below.
See eupro_ug_en.pdf in the \isolinux\diag folder of EXPRESSBUILDER for the End-User
Mode (Professional) feature.
[Supervisor-Mode] is perpared for maintenance personnel.
54
Important
Before executing the System Diagnostics, be sure to disconnect the LAN
cable. Executing the System Diagnostics with the LAN cable connected may
affect the network.
Tips
No data is written to the disk on checking hard disk drives.
Note In case Language Selection menu appears, select English.
If " Hit key to continue. [y|Y] " is displayed in Redirection mode, press <y> key (or
<Y> key).
Express5800/R120f-1M, R120f-2M Maintenance Guide
8. System Diagnostics