Example: Recording A Race Lap Time - Casio 5537 Operation Manual

Interpreting the Difference with the
●
Target Time
The difference between a lap time and the
target time is indicated by the second hand.
The time difference is indicated in the area
from 9 o'clock to 5 o'clock.
10 seconds fast
20 seconds fast
30 or more
1
seconds fast *
2
10 or more seconds slow *
5 seconds slow
*1 If the lap time is 30 or more seconds faster
than the target time, the second hand will be
at the 9 o'clock position.
*2 If the lap time is 10 or more seconds slower
than the target time, the second hand will be
at the 5 o'clock position.
Target Time Beep Alert
●
You can use the procedure below to configure
a setting so the watch sounds a tone when the
lap time reaches the target value during
measurement.
1.
Hold down (A) for at least two seconds.
This displays the target time setting
●
screen.
2.
Press (D).
This displays the beep alert setting
●
screen.
3.
Press (E) to change the beep alert setting.
[♪ON]: Beep alert enabled.
[♪OFF]: Beep alert disabled.
4.
Press (A) to exit the setting screen.
Operation Guide 5537
Example: Recording a Race
Lap Time
This section explains how to measure lap
times while watching a race, and check the
difference between a lap time and target time.
It also shows how you can view lap times with
EDIFICE Connected after the race is over.
5 seconds fast
Lap Times
l
Same as
target time
Before a race
At this time, you should specify the target time
type. If you specify TARGET as the target
value type, you should also specify the
TARGET time.
Using EDIFICE Connected to Change the
l
Target Time Type
Using Watch Operations to Change the
l
Target Time Type
Configuring TARGET Time Settings
l
During a race
Measure lap times.
1.
X Hold down (D) for at least two seconds.
This will cause the watch to enter the
Timekeeping Mode.
2.
X Press (D) once.
This will cause the watch to enter the
Stopwatch Mode.
Minutes, seconds, 1/1000 seconds
Speed
Lap evaluation
3.
X Use the operations below to measure
lap times.
E
Start
E
E
A
Stop
Pressing (E) at the end of each lap will
record each lap time in watch memory.
Lap times are recorded in 1/1000-
●
second units during the first hour of an
elapsed time measurement session.
After one hour, times are recorded in
1/10-second units.
The difference between a lap time and
●
a target time specified by you is
indicated by the second hand.
Interpreting the Difference with the
l
Target Time
4.
X Press (A) to reset the stopwatch time to
all zeros.
5.
X Hold down (D) for at least two seconds
to return to the Timekeeping Mode.
After a race
After the race is finished, you can view the
measure lap times with EDIFICE Connected.
Sending Stopwatch Data to a Phone
l
Checking a Lap Time
l
11