Basic Setup - Russound CAV6.6 Instruction Manual

ii. TEMPLATE TYP –
(TType)
b. Selected: Unassigned
(Unasg)
c. All Other Selections:
4. DEVICE CODE –
(DevCd)
5. TEST IR? –
(TstIR)
6. SUCCESS? –
(OK?)
7. USE NUM IR? –
(NumIR)
8. HIGHEST NUM –
(High#)
9. AUTO PLAY? –
(AtoPl)
10. SAVE CHANGES? –
(Save?)
KEY CONFIG (KeyCf)
Key Configuration defines zone-specific key functions for each source. See Key Config. - Flow Chart
on page 63
1. ZONE NUM –
(Zone#)
Select the template type to define what type of source compo-
nent is being used. (This will tell the CAV 6.6 how to configure
the key commands and text for the source component if it is a
learned source.) Procedure advances to USE NUM IR? (step 7).
The template for the selected source is cleared. (All key
assignments and other source settings will be erased.)
Procedure advances to SAVE CHANGES (step 10)
Procedure advances to DEVICE CODE (step 4)
Enter source component code number listed in this manual's
Reference section.
If "Yes" is selected, the CAV 6.6 sends a power command to the
source component. If "No" is selected, the procedure advances
to USE NUM IR? (step 7)
If the power to the source component was turned off, select
"Yes" otherwise select "No." By selecting "No" the Procedure
returns to DEVICE CODE (step 4) to allow selection of another
code number from the provided list.
Indicates the source component has numeric scrolling, such as
multi-disc CD player (See NUMERIC IR Setup Procedure for
advanced settings or more information). "No" advances menu to
AUTO PLAY (step 9).
Enter the highest possible number; for example, a 100-disc CD
player would have a max number of 100.
"Yes" tells the CAV 6.6 to issue a PLAY command whenever the
source is selected for listening. This option is skipped if the
source type (COMMAND TYPE) chosen does not have a PLAY
command associated with it.
Select "yes" to save changes. Procedure returns to SOURCE
NUM to allow configuration of another source.
Select the zone the key will be configured for. Changes are made
for that zone only; default setting is "All Zones."
INSTALLER
INSTALLATION MENU
Basic Setup (cont'd.)
51