Table of Contents
Advertisement
Source Audio Connections
The CAM6.6 supports up to six audio sources.
The Source Inputs are located at the back panel.
The Source 1 input serves a dual purpose. If the
CAM6.6 optional internal source is used, the
Source 1 inputs are not available, and the switch
next to it is set to "Internal Source Output." If the
Optional Internal Source is not installed, or if you
want to utilize the Source 1 inputs, set the switch
to "Input" and reconfigure Source 1 in the Source
Setup Menu. Connect each source output using
quality RCA signal cables. Connect the Left and
Right Audio outputs from each source to the cor-
responding inputs on the CAM6.6 controller. Label
each cable with the name of the selected source
and the Source Audio input number located on
the CAM6.6.
CAM6.6 with Optional Internal Source - XM satellite radio
Use the source 1
output/input switch
for audio out of the
optional internal
source or audio in
of connected
source equipment.
Source Audio and IR Input Connections
CD Changer
Tape Player
MAKING CONNECTIONS
Source IR Connections
Each source component has a designated IR
port on the back of the CAM6.6. This IR port is
directly above the Source Audio Input
Connections.
1. Using an IR emitter (the Russound 845.1 is
recommended), attach the end of the emitter
"
with the 1/8
plug to the IR emitter port above
the source input.
2. Remove the adhesive back at the other end
of the emitter and attach the emitter over the
source component's IR window.
3. In order to control this source component
with IR, the source must be selected at the
keypad receiving the command.
A
NTENNA
INSTALLER
CAM6.6
37
Advertisement
Table of Contents
