Table of Contents
Advertisement
INSTALLER
INSTALLATION MENU
2. BANK NAME –
(BnkNm)
CONTROLLR ID (CtlId)
This procedure is used to identify the controller(s) that the tuner will respond to. See Periph Setup
- Flow Chart page 68
1. Controller:# –
(CtlId)
2. All controllers –
(All)
DIAGNOSTICS (Diags)
This procedure is for factory use only.
FACTORY INIT (FInit)
NOTE: This procedure returns the tuner to its factory settings and erases all user settings.
This procedure allows the erasure of all programmed settings and returns them to the factory default
settings. See Periph Setup - Flow Chart 68
1. Are you sure? –
(Sure?)
2. Please Wait –
3. Cycle Power –
SYSTEM INFO (SInfo)
System Info shows the tuner's manufacturing build properties. See Periph Setup - Flow Chart 68
BUILD TIME (BTime)
54
Use the up/down keys to select a character and left/right keys
to change a character position. A blinking cursor indicates the
placement of the character being entered. Names can be from 1
to 12 characters in length.
Select controller ID of controller that will control tuner.
Select if all controllers in system can control the tuner.
See Periph Setup - Flow Chart page 68
Confirmation of YES or NO is required to proceed. A NO
selection returns to the top of the Factory Initialization menu.
A YES selection begins the initialization.
Message shows during the initialization process.
When initialization is complete, cycle power to the unit.
BUILD DATE (BDate)
VERSION (Ver)
Advertisement
Table of Contents
