Table of Contents
Advertisement
To begin the Amp/Receiver Key Configuration Procedure, select KEY CONFIG from the Amp/Receiver Setup Menu and press
1.
SELECT A KEY – Press
2.
COMMAND TYPE – Select and enter the type of command. Choose one of the following options:
a.
Select and enter Default to use the same command type previously selected in BASIC SETUP.
i.
KEY FUNCTION – Select and enter the function you want the key to perform.
b.
Select and enter Learned IR to use a learned IR command not included in the command type previously selected in
BASIC SETUP. (See Learn IR Procedure on page 25.)
i.
KEY FUNCTION – Select and enter the function you want the key to perform.
c.
Select and enter a specific device (e.g., Tuner/Amp) to use an IR device code from the built-in library.
i.
DEVICE CODE – Select and enter the amp/receiver's IR device code from the Reference section of this manual.
ii.
KEY FUNCTION – Select and enter the function you want the key to perform.
d.
Select and enter Macro to configure the key with a macro. (To build macros, see Macro Editor Procedure on page 38.)
i.
MACRO ID – Select and enter the macro ID number.
e.
Select and enter Unassigned to clear the key configuration. Any custom settings for that key will be erased.
3.
SAVE CHANGES? – Select and enter Yes to save changes. Procedure returns to SELECT A KEY (step 1).
Learn IR Procedure (Conditional)
This procedure allows you to teach the keypad IR commands from a remote control. It's typically used when there is no IR device
code in the keypad's built-in library for a particular device or when you want to program a special command for key configuration or
a macro. It's important to understand the Learn IR procedure doesn't automatically assign the learned commands; rather, it only
stores the commands in the library. The commands must be assigned separately in other programming procedures.
There are nine locations in the library to store learned IR commands: one for the amp/receiver and one for each of eight sources.
or
to select a key to be configured. Press
INSTALLER
Programming Menu Instructions
to enter your selection.
.
25
Advertisement
Table of Contents
