Programming Port - Russound SaphIR K2 Instruction Manual

INSTALLER

Programming Port

1 SETUP BUTTON – Accesses and clears the programming menu for manually programming the keypad and getting information
2 PROGRAMMING PORT – Connects to a computer for keypad programming, configuration backup, and firmware updates
3
IR LEARNING RECEIVER DIODE – Receives signals from a remote control when the keypad is learning IR commands
18
2
Programming Port
The Programming Port is used for programming the SaphIR
K2, backing up the keypad configuration, and updating the
keypad firmware with a Windows-based computer. These pro-
1
cedures require a Programming Cable, Russound part num-
ber 2500-121036.
DATA
Keypad Programming
The SaphIR K2 can be programmed by using Russound's free
DATA
EZpro software on a computer. You can download EZpro from
GND
the Infrared Products page in the Document Center at
www.russound.com.
Configuration Backups
+12VDC
The K2 keypad configuration can be backed up to a comput-
er using either EZpro or Russound's RNET Backup Utility. The
Backup Utility is available on the RNET Systems page in the
3
Document Center at www.russound.com.
Firmware Updates
From time to time Russound may issue updated firmware for
the SaphIR K2 keypad, which you can load into it from a com-
puter. Any firmware update files and associated instructions
are available on the Infrared Products page in the Document
Center at www.russound.com.