Table of Contents
Advertisement
INSTALLER
Programming Menu Instructions
The following sections describe the menus, procedures, and features. They are presented in the order we recommend for manually
programming the keypad (when not using SaphIR EZpro software). The flow charts on pages 43–53 are shown in the same order.
Programming Menu Top Level
Press the Setup
button to enter the Programming Menu. The following items are available at the top level of the menu:
SOURCE SETUP
AMP/RCVR SET
POWER MGT
LEARN IR
MACRO EDITOR
SYSTEM
Press either the Previous
or Next
key to select an item and press the Play
key to enter the item.
AMP/RECEIVER SETUP MENU
The Amplifier/Receiver Setup Menu enables you to program the keypad with the IR commands the amplifier or receiver needs for
source selection and volume control. This programming is necessary for the keypad's Source and Volume keys to work. Also, the
amplifier or receiver must be IR controllable to perform these functions from the keypad.
The keypad's IR device code library contains codes for most IR-controllable amplifiers and receivers. If you don't find a device code
for the amp/receiver, you will need to use the Learn IR procedure to teach the keypad the commands from the amp/receiver's
remote control. Typically, the commands to be learned are Power (or On and Off), Volume Up, Volume Down, and Input 1 through
Input 8.
To enter the Amp/Receiver Setup Menu, select AMP/RCVR SET from the top level of the Programming Menu and press Play
.
The Amplifier/Receiver Setup Menu offers the following procedures:
BASIC SETUP
KEY CONFIG
Amp/Receiver Basic Setup Procedure (Required)
This procedure selects a command template for basic operation of the amplifier or receiver. This is necessary for the keypad to
control the amp/receiver. Before you perform this procedure, connect an IR emitter or link cable between the 857 connecting block
23
Advertisement
Table of Contents
