Ricoh SP C360 series User Manual page 105

• To use the paper size and feed direction other than those indicated on the paper size dial, set the
dial to " ", and set the paper size using the control panel.
• If you load paper whose size is not indicated on the paper size dial, you can specify the paper size
in [Tray Paper Settings]. For details, see "Changing Paper Size Settings", Paper Specifications and
Adding Paper.
• Make sure the paper stack does not exceed the upper limit mark inside the paper tray. Excessive
stacking can cause paper jams.
• If paper jams occur frequently, flip the paper stack in the tray.
• Do not mix different types of paper in the same paper tray.
• After loading paper, specify the paper size using the control panel or paper size dial, and paper
type using the control panel. When printing a document, specify the same paper size and type in
the printer driver as specified on the machine.
• Do not move the side paper guides and end paper guide forcefully. Doing so may damage the
tray.
• Do not slide the paper tray in forcefully when inserting the loaded tray into the machine. Otherwise,
the side and end guides or the paper guide of the bypass tray might move.
• When loading label paper, load it one by one.
1. Pull out the paper tray carefully. Adjust the paper size dial to match the size and feed
direction of paper in the paper tray.
• Tray 1
• Tray 2
DUP101
Loading Paper
103