Table of Contents
Advertisement
Installation
3.6
Mounting the
VX-3000d
Floor Mounting (Upright)
Ceiling Mounting
(Inverted)
Adjusting the Projector
Height or Projection Angle
There are several methods for mounting the projector. Depending on your chosen
installation, one method may be more suitable than another.
➤
In typical front and rear screen installations, the projector can be mounted to a secure and
level surface such as a table or cart. Carts are useful when moving a projector during a
presentation or from site to site. If possible, lock the wheels when it's in position to prevent
it from being moved during a presentation.
➤
For fixed installations, and for those that want the projector out of sight or have a limited
space for projector and audience, you can invert the VX-3000d and suspend it from the
ceiling using a specially-designed ceiling mount fixture.
Note
The projector can also be inverted and placed in an enclosure above and behind the
viewing area. Install four feet on the inside bottom surface of the enclosure on which the
projector can rest. A variety of materials can be used for this purpose (for example, rubber
crutch tips or turntable feet).
➤
If the screen is significantly higher or lower than the projector (such as in a rear-projection
installation), you can tilt the projector at an angle. In a ceiling installation, you do this by
adjusting the ceiling mount.
The projector can be rotated (front-to-back) up to 30 degrees and mounted without it
affecting performance. However, to ensure optimal performance of the lamp, limit the
side-to-side tilt of the projector to ±15 degrees; see Figure 3-13.
Figure 3-13. Mounting Angle Ranges (Front-to-Back and Side-to-Side)
Use only the Runco-approved ceiling mount kit designed for your
projector. Install the mount kit according to the instructions
provided with it.
± 30º
max.
38
VX-3000d Series Installation/Operation Manual
± 15º
max.
Advertisement
Table of Contents
Troubleshooting
