Installing The Fixed Cinewide Base Plate (Prismatic Lens) - Runco CINEWIDETM VX-3000D Installation & Operation Manual

To install the fixed CineWide base plate on a VX-3000d/CineWide or
VX-3000d Ultra/CineWide with a prismatic anamorphic lens:
1. Place the projector upside down on a blanket or other soft surface.
2. For a standard VX-3000d/CineWide that is to be ceiling-mounted: Line up the
four holes on the projector ceiling mounting plate (included with the projector ceiling
mount kit) with those on the bottom of the projector.
3. Line up the two mounting holes on the CineWide base plate with those on the bottom
of the projector (and at the front of the ceiling mount plate, if present).
4. Secure the CineWide base plate (and ceiling mounting plate, if needed) to the
projector with the M6x12mm screws and washers provided with the CineWide lens
base plate. See Figure 3-10.
1. Do not use the mounting screws provided with the ceiling
Caution
mounting plate. Use only the hardware provided with the
CineWide lens base plate.
2. DO NOT OVER-TIGHTEN THE SCREWS.
3. Washers are not needed to install the base plate on a
VX-3000d Ultra.
VX-3000d Series Installation/Operation Manual 33
Installation
Installing the Fixed
CineWide Base Plate
(Prismatic Lens)